Installing The Communication Cabling - ADS-tec StoraXe PowerBooster GSS0608 Manual

Installation

7.5.3 Installing the communication cabling

The procedure described in the following for assembling the storage system is to be observed under all
circumstances. The designation on the SRB modules is CAN-BUS1 for the input and CAN-BUS2 for the
output to the next module. The module label can be found imprinted on the front label of the module.
F 29: A
IGURE TTACHING THE COMMUNICATION CABLE
F 30: A
IGURE TTACHING THE COMMUNICATION CABLE
Version:1.3
Communication cable 1 (short)
1
Connect the communication
•
cable from SRC4310 to the first
CAN-BUS1 battery module.
- 1
Communication cable 2
2
Connect the next communication
•
cable from the first to the second
battery module CAN-BUS1.
- 2
GSS0608 Page 51 of 72