Installing The Battery Modules; Inserting The Battery Modules - ADS-tec StoraXe PowerBooster GSS0608 Manual

Installation

7.5 Installing the battery modules

NOTE
Observe qualifications.
Only qualified electricians are allowed to install the battery modules!

The procedure described in the following for assembling the storage system is to be observed under all
circumstances. The module label can be found imprinted on the front label of the module.

7.5.1 Inserting the battery modules

Owing to the heavy weight of the SRB modules, it is essential to follow the procedure described below for
installing the components. The SRB modules are equipped with a transport safety device on the plus
pole. Do not remove the transport safety device when installing the modules in the cabinet. They are only
to be removed within the scope of the DC cabling.
WARNING
Risk of death from falling and tipping loads!
Falling and tipping loads can cause fatal injury.
The battery module is very heavy and must be installed by two people at a

minimum. Refer to the technical data for the exact weight.
To lift loads, use only lifting equipment that is suitable for the task and in

perfect working order. Lifting eyes are provided on the top of the modules.
Make sure that no persons are located in the hazardous area underneath the

suspended load.
Due to their heavy weight, install the battery modules from the bottom up.

Wear the appropriate protective equipment.

WARNING
Risk of crushing and cuts from sharp edges!
Inserting the battery modules may cause crush injuries and cuts.
Wear gloves.

Have at least 2 people install the battery module.

Version:1.3 GSS0608 Page 45 of 72