Table of Contents
Advertisement
Installation
7.5.2 Installing the power cabling
The procedure described in the following for assembling the power cabling is to be observed under all
circumstances. The module label can be found imprinted on the front label of the module.
The modules are equipped ex factory with a transport cover on the plus pole. This transport cover is
screwed to the module with Torx-TR 20 safety screws. All cables are included in the scope of delivery.
NOTE
Observe the assembly sequence.
Do not remove the transport cover until requested to do so in the described
installation sequence. The sequential procedure prevents incorrect cabling and
ensures safe installation.
F
22: T
IGURE
RANSPORT COVER INFORMATION
NOTE
Observe the key switch position.
Before beginning the installation, make sure that the key switch of the SRC4310
is in the "OFF" or "Service" position.
Check the power cables for damage. If damaged:
Do not use the power cables!
The power cables have coded plugs. The power cable negative plug only fits into the minus pole of the
module. Similarly, the positive plug only fits into the plus pole of the module.
The power cables can be securely connected to the battery module with four screws. Tighten the screws
crosswise to 0.5 Nm.
Version:1.3
(
EXAMPLE
)
FIGURE
GSS0608
Transport cover
1
INFO:
Remove the transport cover on the
individual battery modules only during
the respective installation step.
Page 47 of 72
Advertisement
Chapters
Table of Contents
