HP 8560E Service Manual page 168

5. Connect A18W1 to A17J5.
6. Snap CRT cable W9 onto the end of the CRT assembly.
7. Fully seat the front frame and CRT assemblies into the spectrum
analyzer.
8. Secure the front frame to the spectrum analyzer side frames, using
three flathead screws per side. See
9. Retighten the four screws securing the CRT clamps to the deck.
10.Place W9 between the CRT assembly and the A6 power supply
assembly top shield so that the W9 wires are underneath the surface
of the top shield.
11.Connect W42 to A7J3 and the front panel 1ST LO OUTPUT
connector. For Option 002 spectrum analyzers: connect W46 to the
front panel 1ST LO OUTPUT connector.
12.Use a 9/16-inch nut driver to reconnect CAL OUTPUT connector to
the front panel.
13.Connect the VOLUME potentiometer and knob to the front panel.
14.For Option 002 spectrum analyzers: use a 5/16-inch open-end wrench
to connect W47 to the front panel RF OUT connector.
15.Connect W36, coax 86, to the front panel IF INPUT connector.
16.Use a 5/16-inch wrench to connect W41 from the A9 input attenuator
to the front panel INPUT 50 Ω connector. Make sure that W40, W36,
and A1W1 are routed between W41 and the attenuator bracket.
Secure the A9 input attenuator bracket to the center support on the
front frame using one panhead screw. See
(2).
17.Place led A1W1DS1 into the line-power switch assembly.
18.Attach the line switch assembly into the front frame using one
panhead screw. Be sure to connect the line-power switch ground lug
with the screw. The screw is captive.
19.Fold up the A14 and A15 assemblies as described in steps 3 through
5 under "Procedure 9. A14 and A15 Assemblies Replacement."
20.Place the spectrum analyzer top-side-up on the workbench and
connect A1A1W1 to A3J602.
21.Snap post-accelerator cable A6A1W3 to the A18 CRT assembly.
22.Snap the black grommet protecting the A6A1W3 into the CRT
shield.
23.Fold up assemblies A2, A3, A4, and A5 as described in steps 6
through 12 under "Procedure 5. A2, A3, A4, and A5 Assemblies
Replacement."
Chapter 3
Assembly Replacement
Procedure 2B. A1 Front Frame/A18 CRT (8560E)
Figure 3-5 on page
Figure 3-4 on page 163
164.
167