Renesas RTE7702500EAB00000J User Manual page 41

Emulation Adapter
3.2.2 Settings for Use as an Emulation Board
Table 3-4 shows a list of the recommended settings of the emulation adapter for this system
configuration.
Table 3-4 Recommended Settings for Use as an Emulation Board
Item
Debug chip: IC1
Connector for external tracing: CN1
Power-supply connector: CN3
Clock socket: X1
Jumper block: JP5 (VDD_SEL)
Jumper block: JP10 (AURORES)
Jumper block: JP11
(EXAURORES)
Jumper block: JP14 (TRST_SEL)
Jumper block: JP2 (FLMD0)
Jumper block: JP12 (FLMD0_SEL)
Jumper block: JP9 (FLMD1)
Jumper block: JP13 (FLMD1_SEL)
Jumper block: JP15 (RES_SEL)
Jumper block: JP1 (VDD_EMU)
Jumper block: JP4 (EMUVDD)
Jumper block: JP6
(EMUVDD_SEL)
Jumper block: JP3 (EMUVCC)
Jumper block: JP7 (SBMD)
Jumper block: JP8 (AWOVCL)
Interfaces for the exchange
adapter: CN10 and CN11
R20UT5180EJ0110 Rev. 1.10
Sep.12.22
Set an option byte. Refer to section 4.1.
When an emulator is in use: Connect the cable for the emulator, the 14-
pin to 46-pin conversion adapter, or the 34-pin to 46-pin conversion
adapter.
When an emulator is not in use: Leave the connector open-circuit.
Set up a +5-V supply through the attached power-supply cable.
If you are using the IE850A, power can be supplied from the power-
supply cable attached to the IE850A.
A resonator is mounted (20 MHz as shipped).
When you are evaluating the emulation adapter with a different
frequency or with a crystal oscillator as the main oscillator, change the
resonator or exchange it for an oscillator.
1-2 short-circuit (default)
1-2 short-circuit (default)
1-2 short-circuit (default)
1-2 short-circuit (default)
1-2 short-circuit (default)
1-2 short-circuit (default)
2-3 short-circuit (default)
1-2 short-circuit (default)
1-2 short-circuit (default)
Short-circuit (default)
1-2 short-circuit (default)
1-2 short-circuit (default)
Short-circuit (default)
Select the connection on this jumper block according to the emulation
mode to be used. Refer to (19) in section 2.1.
Select the connection on this jumper block according to the emulation
mode to be used. Refer to (20) in section 2.1.
Connect these connectors to the base board.
System Configuration and Setup
Description
Page 31 of 63