Renesas RTE7702500EAB00000J User Manual page 24

Emulation Adapter
(2) Switch: SW1 (POWER SW)
SW1 (POWER SW)
ON
OFF
(default)
Operating the switch:
(3) Switch: SW2 (RESET SW)
SW2 (RESET SW)
(L)
H
(default)
L
R20UT5180EJ0110 Rev. 1.10
Sep.12.22
This switch turns on the power supply of the base board.
Turn this switch on after connecting the emulation adapter and starting the
supply of power from CN3 of the emulation adapter.
This switch turns off the power supply of the base board.
Do not operate a switch before removing static electricity from the operator's body.
Doing so may lead to the discharge of static electricity and so damage the internal
circuits.
This position starts release from the reset state after the debug chip has been
reset.
The switch returns to the "H" position a moment after it stops being pressed.
The state of the reset pin of the debug chip changes from "L" to "H" (pulled up).
Reset released state.
The reset pin of the debug chip is in the "H" (pulled up) state.
Reset state.
The reset pin of the debug chip is in the "L" state.
Names and Functions of Hardware
Specification
CAUTION
Specification
Page 14 of 63