Table of Contents
Advertisement
Emulation Adapter
3.1.2
Procedure for Setting the Emulation Adapter up as a Simple Evaluation Board
This section describes the procedure for setting the emulation adapter up for use as a simple evaluation
board.
(1) Settings on the boards
Make settings for the emulation adapter and base board according to the statements in section 3.1.1.
Turn off the SW1 switch (POWER SW) on the base board and set the SW2 switch (RESET SW) for the
low level.
(2) Connecting the power-supply cable
Connect the power-supply cable which comes with this product to the CN3 power-supply connector of
the emulation adapter then connect a power-supply unit such as a stabilized power supply. Do not turn
the power on.
If you are using an IE850A emulator, power can be supplied by connecting the power-supply cable
attached to the IE850A.
(3) Connecting the emulation adapter to the base board
Connect the two boards so that the sticker and silk-screened mark for aligning the positions of pin 1 of
the emulation adapter and base board are in the same position.
(4) Connecting the emulator (only if you are using an emulator)
Connect the emulator to the CN1 connector for external tracing from the emulation adapter. If you are
using an emulator (e.g. an IE850A) that supports external tracing (Aurora tracing), connect the emulator
cable via the 34-pin to 46-pin conversion adapter. If you are using an emulator (e.g. an E2 emulator)
that supports a 14-pin connector, connect the emulator via the 14-pin to 46-pin conversion adapter.
Connecting the emulator:
(5) Turning on the emulator (only if you are using an emulator)
Turn on the emulator. For details, refer to the manuals for the emulator you are using.
R20UT5180EJ0110 Rev. 1.10
Sep.12.22
Confirm the direction with the notch on the connector and connect the emulator while
taking care that the direction of insertion is correct.
System Configuration and Setup
CAUTION
Page 26 of 63
Advertisement
Table of Contents
