Renesas RTE7702500EAB00000J User Manual page 42

Emulation Adapter
3.2.3 Procedure for Setting the Emulation Adapter up as an Emulation Board
This section describes the procedure for setting the emulation adapter up for use as an emulation
board.
(1) Settings on the boards
Make settings for the emulation adapter according to the statements in section 3.2.2.
(2) Connecting the power-supply cable (when the power is supplied from CN3)
Connect the power-supply cable which comes with this product to the CN3 power-supply connector of
the emulation adapter then connect a power-supply unit such as a stabilized power supply. Do not turn
the power on.
If you are using an IE850A emulator, power can be supplied by connecting the power-supply cable
attached to the IE850A.
(3) Connecting the emulation adapter to the exchange adapter
Connect the two boards so that the positions of pin 1 of the emulation adapter and of the exchange
adapter are in the same position.
(4) Connecting the exchange adapter to the target system
The target connector (BSSOCKET) must be mounted on the pad pattern for the target device of the
target system in advance.
After that, connect the exchange adapter to the target connecter mounted on the target system.
Connecting the exchange adapter:
(5) Connecting the emulator (only if you are using an emulator)
Connect the emulator to the CN1 connector for external tracing from the emulation adapter. If you are
using an emulator (e.g. an IE850A) that supports external tracing (Aurora tracing), connect the emulator
cable via the 34-pin to 46-pin conversion adapter. If you are using an emulator (e.g. an E2 emulator)
that supports a 14-pin connector, connect the emulator via the 14-pin to 46-pin conversion adapter.
Connecting the emulator:
R20UT5180EJ0110 Rev. 1.10
Sep.12.22
Connect the exchange adapter to the target system by aligning the positions of pin 1 of
the target connector and of the exchange adapter and confirming that the contact pins of
the exchange adapter are not bent.
Confirm the direction with the notch on the connector and connect the emulator while
taking care that the direction of insertion is correct.
System Configuration and Setup
CAUTION
CAUTION
Page 32 of 63