Table of Contents
Advertisement
Emulation Adapter
Table 3-2 Recommended Settings for Use as a Simple Evaluation Board (Base Board)
Item
Interfaces for the exchange
adapter: CN10 and CN11
Switch: SW1 (POWER SW)
Switch: SW2 (RESET SW)
Jumper blocks: JP1 to JP21
(selecting each of the power-supply
voltages)
Jumper block: JP22 (FLMD0)
Jumper block: JP23 (FLMD1)
R20UT5180EJ0110 Rev. 1.10
Sep.12.22
Connect these connectors to the emulation adapter.
Refer to (2) in section 2.2.
Refer to (3) in section 2.2.
The voltage of each power supply is selected according to the conditions
to be evaluated or the specifications of the target device. Refer to (5) in
section 2.2.
Open-circuit (default)
Open-circuit (default)
System Configuration and Setup
Description
Page 25 of 63
Advertisement
Table of Contents
