Table of Contents
Advertisement
Emulation Adapter
(6) Disconnecting the emulation adapter from the exchange adapter
To disconnect the emulation adapter from the exchange adapter, insert the demounting lever which
comes with this product into alternate corners among the four corners between the two boards and
gradually pull the emulation adapter out. Take care of the positions where you insert the demounting
lever so that you do not accidentally tear off components on the boards. For details, refer to section 2.6.
(7) Disconnecting the exchange adapter from the target system
Disconnect the exchange adapter from the target system.
For details, refer to appendix A, Specifications of the Exchange Adapters.
(8) Disconnecting the power-supply cable (when the power is supplied from CN3)
Disconnect the power-supply cable from the CN3 power-supply connector of the emulation adapter.
When disconnecting the power-supply cable from the emulation adapter, press the tabs on both sides
of the CN1 connector of the power-supply cable to unlock the connector.
Unlocking the connector:
R20UT5180EJ0110 Rev. 1.10
Sep.12.22
Do not press the tabs for unlocking the connector too hard as this may lead to them
being stuck in this position. Take care on this point.
System Configuration and Setup
CAUTION
Page 34 of 63
Advertisement
Table of Contents
