Operating Ptz Control; Operating Ptz Movement - HIKVISION DS-6700HFHI/V Series User Manual

DS-6700HFHI/V Series Network HD Encoder User Manual

The saving path for the captured pictures can be set at the Configuration > Local Configuration page.

The image is saved as a JPEG file on your computer.

5.3 Operating PTZ Control

Before you start:
1. Make sure the encoder is connected with the camera/dome which supports PTZ function. Connect the R+
-
and R terminals of the pan/tilt unit or speed dome to RS-485 D+ and RS-485 D- terminals of the DS-6700
respectively.
2. The baud rate, PTZ control and address configured in the RS-485 Settings interface (Configuration >
System Settings > RS485), as shown in Figure 5.4, must be the same with the parameters of the connected
pan/tilt unit or speed dome.

5.3.1 Operating PTZ Movement

In live view mode, you can use the PTZ control buttons to realize pan/tilt/zoom control of the camera lens.
There are 8 directional buttons (up, down, left, right, upper left, upper right, bottom left, bottom right) on the
display window when the mouse is located in the relative positions.
Figure 5. 3 Picture Capture Succeeded
Figure 5. 4 RS-485 Settings
20