Table of Contents
Advertisement
User Manual of DS‐6101DI Decoder
Pause cycle decoding
Right click the current cycle decoding window,
and select the Pause cycle decoding or click
to pause the cycle decoding.
Resume cycle decoding
When the cycle decoding is in paused status,
user may right click on the decoding window
and select Resume cycle decoding or click
to start cycle decoding again.
Configure the cycle decoding dwell time
Click
to enter the setup management interface and then click Local Settings to enter preview settings
interface (refer to the following figure) which allows user to set the TV Wall Dwell Time.
After configuring the time, click the Save button to save the configuration.
It is recommended to set the dwell time of cycle decoding to be longer than 5s.
Note:
4.5.3 PTZ Control
If the decoder is connected with PTZ, user can operate the PTZ
control through the client software.
There are 8 directional keys to control PTZ movement, and the
sliding bar is used to change PTZ speed, which is adjustable
from 1 to 7, and the default speed is 4.
29
Advertisement
Table of Contents
