Omron C200H-ASC11 Manual page 222

Details of BASIC Commands
renum
Syntax:
RENUM
Command. Renumbers program lines.
Description:
<new line number> is the first line number to be used in the new sequence. It can be any valid
Remarks:
line number in the range : [1...65535]. If it is omitted then it has a default value of 10.
<old line number> is the first line number in the current program where renumbering should
begin from. It can be any valid line number in the range : [1...65535]. If it is omitted then it
defaults to the first line of the program.
<increment> is the increment to be used in the new sequence. It can be any valid integer in the
range : [1...65535]. If it is omitted then it has a default value of 10.
The
GOSUB
If the
"ILLEGAL FUNCTION CALL" error (code B005) will result.
> 1 REM FIRST LINE
Examples:
> 2 REM SECOND LINE
> 3 GOTO 3
> RENUM 100, 1
> LIST
100 REM FIRST LINE
110 REM SECOND LINE
120 GOTO 120
>
See also:
restore
Syntax:
RESTORE
Description: Statement. Resets the next data item to first item in the
number.
<line number> is any valid line number in the BASIC program containing a
Remarks:
valid range is : [1 ... 65535].
<label> is a BASIC program label. It references a line number somewhere in the BASIC program.
If the <line number> and <label> are omitted then the data pointer will be restored to the first
statement in the BASIC program.
If the specified <line number> does not exist in the BASIC program, an "UNDEFINED LINE
NUMBER" error (code B008) will occur.
Examples: > 10 DATA 10, "HELLO", 1.6, "WORLD"
> 20 READ A, B$, C, D$
> 30 PRINT B$+" "+D$
> 40 PRINT A+C
> 50 RESTORE 10
> 60 READ A, B$, C, D$
> 70 PRINT A+C
> 80 PRINT B$+" "+D$
> RUN
HELLO WORLD
11.6
11.6
HELLO WORLD
See also:
DATA
[<new line number>][,[<old line number>][, <increment>]]
statement also changes the line number references used in the program in
RENUM
, ... ... and
IF THEN ELSE RESTORE
statement would cause an invalid program number then it is not executed. An
RENUM
[(<line number> | <label>)]
,
READ
statements.
statement specified by the line
DATA
7-6
Section
,
GOTO
statement. The
DATA
DATA
213