Arjohuntleigh Bari-Breeze User Manual page 13

If the bed can be profiled to any position (i.e. raised or lowered), attach the
mattress to the movable parts of the bed only.
Care should be taken such that the air inlet vent on the pump is not covered,
and the pump is not placed on the floor in such a manner that it is a hazard.
Care should be taken such that the mattress hose is freely suspended without
being pinched or kinked.
3. There are ten nylon black straps with buckles, on
the base of the mattress. Loop each strap around the
bed frame and fasten it securely to the bed frame
using the buckle.
4. Open the hooks on the back of the pump and
suspend the pump from the bed foot rail. If the bed
you are using does not have a foot rail, place the
pump on its base (not on its back where the filter is
located) on a flat surface underneath the bed near
the foot of the bed frame.
5. Plug the power cord into the pump and press it in
place. Uncoil the power cord and plug the cord into
a properly grounded AC power source.
6. Securely attach the pump connector onto the pump
until it clicks, and make sure the side bolster and
safety air pad plug is secure.
7. If not already fitted, place the protective cover over
the mattress and secure in position. Make sure the
ArjoHuntleigh
of the mattress.
8. Push the Power/Standby button to turn the pump on
and enter the required therapy settings, see
"Controls, Alarms and Indicators" on page 9.
9. Unzip the cover and ensure the cells, side bolsters,
and the base pad are all fully inflated. Refit cover.
10. Place a bed sheet loosely over the mattress before
use.
7
logo is uppermost and at the foot end