Troubleshooting Guide - Arjohuntleigh Bari-Breeze User Manual

8. Troubleshooting Guide

The following table contains fault symptoms, their possible causes and suggests
steps to rectify the problem. These may occur during initial installation and power
up.
Symptom
Pump keyboard does
not respond.
Mattress does not
inflate when the
system is switched
on.
Mattress inflates but
appears to be noisy as
if a leak has appeared
in the tube-set
connection with the
pump.
Mattress inflates but
doesn't appear to turn.
Mattress inflates but
only appears to turn to
one side.
Mattress turns but
then suddenly stops
mid cycle.
Possible Cause
Lock out is on Lock out button LED
preventing set illuminated.
up.
Pump is left in If the pump is plugged into a
standby mode, power socket, a dash will be
indicated by a visible on the LED display to
single dash on indicate standby mode.
the LED display. Check status of LED display.
Blower failure Check to ensure blower is
within pump unit. generating airflow through
the manifold connector.
Hose-set Check to ensure the hose
connection not connector clicks into place.
correctly fitted.
Bolster/Sub- Check plug is fitted correctly
Mattress plug not in hose manifold.
fitted correctly or
failing. Check integrity of plug.
No turn angle Therapy Settings.
set.
Firm inflate Maxflow
activated.
Dwelling in Check status of LED display.
centre (check
turn time).
Therapy is set for Ensure bilateral therapy
left or right turn setting has been set.
only.
Both setting may For bilateral turn ensure
not be
illuminated.
illuminated).
Maxflow
LED display showing '
activated.
Dwelling in Check status of LED display.
centre (check
turn time).
Check
LED illuminated.
is activated (LED
F
'.
14
Action
Press and hold the lock
button until the LED
extinguishes.
Turn on the pump unit.
If the LED display is blank,
check integrity of power
supply at the wall socket.
If blower has failed call a
Service Engineer to replace
the blower/pump unit.
Re-connect hose connection
to pump, ensuring firm
fitment.
Ensure plug is firmly located.
Replace if neccesary.
Turn
Set angles.
Press the button to
deactivate, and enter
required therapy settings.
If LED display is illuminated
d
with ' ' mattress is dwelling.
Bi-lateral
Enter therapy
settings.
If not, press to select
and ensure the LED
illuminates.
Press the button to
deactivate, and set turn
angles.
If LED display is illuminated
d
with ' ' mattress is dwelling.