Table of Contents
Advertisement
Thermo Scientific
Figure 8-11 Standard weekly program
** The cycle function will only be available if it is activated (see "Special Program
Activation by Date (within yearly time switches)" on page 8-14).
Example for the programming of STANDARD switching times (ON and OFF)
1. If you want to program a standard weekly switching time (on, off) confirm Standard
with
.
2. For regular switching times choose on or off with
.
3. Within this level, you activate the days of the week (1...7) on which the switching
time should happen. With
corresponding date. Confirm each day with
4. Adjustment of the time: Hours
5. Verify the entered switching time: If the flashing summary of the programming step is
correct, verify on or off with
edit/delete and end with
6. If you want to proceed with programming, confirm next switching with
the programming menu confirm end.
Information: You can easily transfer switching times from one channel to another if
you use the copy function.
Cycle
Standard weekly program:
Special (weekly) program (to be activated by date for the yearly function):
For the cycle function it is possible to enter a periodic switching time. The time switch
acts as a recycling timer and switches between pulse (ON) and pause (OFF). The max.
value for pulse and pause is 9:59:59 h:mm:ss.
If you haven't defined and activated a cycle, the cycle function will not be available as
switching time. Therefore you have to activate and define at least one of the four cycles
within menu options and sub-menu Cycle (see "Programming Menu" on page 8-10).
Handling and Control |
buttons and confirm with
you activate "yes" or deactivate "no" the
.
and
. Minutes
. After verification you have the choice between
.
Chapter 8
and
.
. To leave
Model 3900 Series | 8-11
Advertisement
Table of Contents
