Cleaning The Workspace; Final Disinfection; Cleaning The Light Module Reflector - Thermo Scientific 3906 Operating Manual

Thermo Scientific
Risk of injury by removing the glass panel
The glass panel may only be removed by properly trained and authorized
personnel. The glass panel must be held by two persons.
Allow time for disinfectant to act as specified by the manufacturer.
NOTE
Disinfecting hard-to-reach components
Spray hard-to-reach components with disinfectant!

Cleaning the workspace

Thoroughly remove dirt residues and deposits using a solution of tepid water and
dishwashing agent.
Wipe the surfaces clean using a clean cloth and plenty of clear water.
Remove the cleaning liquid and wipe all surfaces of the workspace thoroughly dry.

Final Disinfection

Spray the surfaces of the workspace, the shelving system and the parts removed with
disinfectant one more time and wipe dry.
Allow the disinfectant to act as specified by the manufacturer.
Reinstall the shelf system and the removed components.

Cleaning the Light Module Reflector

Visual check before every start of an application for dirt on the reflector.
If the reflector is dirty:
Remove light module supply line.

Remove the light module and place it "upside down

Remove protective grid and lamps.

Clean reflector with a lint-free cloth and suitable cleaning agent and wipe dry.

Insert lamps and protective grid.

Cleaning and Disinfection |
Chapter 9
"
on a level.
Model 3900 Series | 9-5