Installing The Battery Pack And Cover; Changing Batteries - Kaba 5 00 Series Installation Instructions Manual

I-8
Using two pairs of pliers, break the tailpiece to the desired length of the
intended application by holding one pair of pliers on the good side of the
score mark and a second pair on the other side of the score mark. Slowly
move the 2nd pair of pliers up and down until the unneeded portion of the
tailpiece breaks free.
I-9
Insert the Medeco tailpiece (e) vertically
into the outside lever as shown. Make certain that you rotate the tailpiece
slightly so that it will align with the interchangeable/removable cylinder.
Insert the interchangeable/removable cylinder into the outside lever.
J. INSTALLING THE BATTERY PACK AND COVER /

CHANGING BATTERIES

J-1 To install the battery pack (f) and cover
(g), snap the cable connector (c) onto
the top of the battery pack. Then place
the battery pack into the cover, terminals
at the top. Put the two security screws
(h) into the cover and fasten the cover
to the inside housing with the security
screw tool (i).
Caution: Over-tightening these screws could strip the threads in the housing or
crack the cover.
Warning: If the lock goes without power for more than 2 minutes, you will lose
the lock's current date and time only. If this happens, program the lock with
current date and time. Refer to Operations Manual.
J-2 To change batteries remove the two screws (h) from the battery cover (g)
fastened to the top of the inside housing using the security
screw tool (i) provided with your lock.
J-3 Remove the four depleted batteries and install four new
Alkaline (only) AA batteries. Ensure that each battery
is installed in the proper direction as shown at each
battery location in the battery holder (f).
Warning: Do not install a 9V battery. This E-PLEX lock operates on
4 alkaline only AA batteries (6V). A 9V will ruin the electronics in the
lock and void the warranty.
13
c
f
g
h
i
f