Installing The Battery Pack And Cover - Kaba E-PLEX Installation Instructions Manual

I-10 Insert the lever release tool (d) into the small hole (f) under lever as
shown. Gently push lever catch up until it clicks. Remove tool, then
remove outside lever (a).
Note: You may want to use needle nose pliers for some tailpieces.
Insert the release tool (d) into the small hole (f) under the lever as shown.
Gently push lever catch up until it clicks. Remove tool, then remove the outside
lever (a).
Note: Do not shut door until installing batteries and testing operation as
outlined in the following two sections.
J. INSTALLING THE BATTERY PACK AND
COVER/CHANGING BATTERIES
J-1 To install the battery pack (f) and cover
(g), snap the cable connector onto the
top of the loaded battery pack. Then
place the battery pack into the cover,
terminals at the top. Put the two securi-
ty screws (h) into the cover and fasten
the cover to the inside housing with the
security screw tool (i).
Caution: Over-tightening these screws could
strip the threads in the housing or crack the
cover.
Warning: If the lock goes without power for more than two minutes, you will
lose the lock's current date and time only. If this happens, program the lock
with the correct date and time. Refer to Operations Manual.
J-2 Remove the two screws (h) securing the battery cover to the
housing, using the security screw tool (i) provided with your
lock.
J-3 Remove the four depleted batteries and install four new
Alkaline only AA batteries. Ensure that each battery is
installed in the proper direction as shown at each battery loca-
tion in the battery holder (f).
Warning: Do not install a 9V battery. Your lock operates on 4 alkaline only
AA batteries (6V). A 9V will ruin the electronics in the lock, and void your
warranty!
J-4 Reconnect the battery cable. Place the battery holder into the cover.
Screw the back cover onto the inside housing, ensuring that the cable is
not trapped under the edge of the cover.
Caution: Over-tightening these screws could strip the threads in the housing
or crack the cover.
20
f
g
h
i