Operation In Stand-Alone Mode; Master/Slave Mode - ProLights CROMOBEAM250 User Manual

MENU
(2)

3.4 OPERATION IN STAND-ALONE MODE

If no DMX control signal is present at the jack DMX INPUT (3), and the unit independently runs through its
show programme.
• Press the MENU button and select, via the directional buttons, the [Intro] menu choice, then press the
ENTER button to confirm the choice.
• Press the UP and DOWN buttons to select [Run] menu voice and confirm the choice by pressing the
ENTER button.
• Select a stand-alone operation mode: [Auto1], [Auto2], [Sound1], [Sound2], [Custom] or [Test], and press ENTER
button.
NOTE. When the fixture is on Stand-Alone mode, it will be automatic set as master fixture.

3.5 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the MENU button and select, via the directional buttons, the [Intro] menu choice, then press the
ENTER button to confirm the choice.
• Press the UP and DOWN buttons to select [Run] menu voice and confirm the choice by pressing the
ENTER button.
• Select [Slave] to configure the slave fixtures.
• Select the desired operation mode (see section 3.4).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
CROMOBEAM250
Speed
Color
Gobo1
Edit
Gobo1 Rot
Dimmer
Strobe
Default Default
Step (001-255)
Pan (000-255)
Tilt (000-255)
(000-255)
(000-255)
(000-255)
(000-255)
(000-255)
(000-255)
Time (000-255)
No
Use
Yes
No
Yes
11