ProLights CROMOBEAM250 User Manual page 43

Range function
• Press the MENU button, select the [Range] menu voice and press the ENTER button to confirm the choice.
• Select the parameter to be changed between [P/start], [P/finish], [T/start] and [T/finish]; press the ENTER
button to confirm.
• Set the desired parameter value (0-255) using the UP and DOWN buttons and press the ENTER button
to confirm the setting.
• Press the MENU button to go back or wait 30 seconds for automatic exit from the menu.
Starting point for the limited Pan
P/start
P/finish Finishing point for the limited Pan
T/start Starting point for the limited Tilt
Finishing point for the limited Tilt
T/finish
• Enter [Use] and set [Yes] to run the new setting.
Special function
• Press the MENU button, select the [Special] menu voice and press the ENTER button to confirm the choice.
• Select the parameter to be changed between [Blackdelay] and [Reset]; press the ENTER button to confirm.
• Set the desired parameter value using the UP and DOWN buttons and press the ENTER button to confirm
the setting.
• Press the MENU button to go back or wait 30 seconds for automatic exit from the menu.
Move-in Black
Blackdelay
Reset control
Reset
Display setting
• Press the MENU button and select, via the directional buttons, the [Intro] menu choice, then press the
ENTER button to confirm the choice.
• Press the UP and DOWN buttons to select [Display] menu voice and confirm the choice by pressing the
ENTER button.
• Select a display mode [60close] or [Bright].
When in the [60close] setting, the display backlight will turn off after 60 seconds.
When in the [Bright] setting, the display backlight will stay on.
CROMOBEAM250
No
Yes
Dmx
System
000-255
000-255
000-255
000-255
without delay
3 seconds delay
DMX control reset
DMX cannot control reset
17