Construction Of The Dmx Termination; Adjusting The Start Address - ProLights CROMOBEAM250 User Manual

• Connect the controller DMX input to the DMX output of the first unit.
• Connect the DMX output to the DMX input of the following unit. Connect again the output to the input
of the following unit until all the units are connected in chain.
• When the signal cable has to run longer distance is recommended to insert a DMX termination on the
last unit.

3.10 CONSTRUCTION OF THE DMX TERMINATION

The termination avoids the risk of DMX 512 signals being reflected back along the cable when they reaches
the end of the line: under certain conditions and with certain cable lengths, this could cause them to cancel
the original signals.
The termination is prepared by soldering a 120Ω 1/4 W resistor between pins 2 and 3 of the 5-pin male XLR
connector.

3.11 ADJUSTING THE START ADDRESS

To able to operate the CROMOBEAM250 with a light controller, adjust the DMX start address for the first a
DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the CROMOBEAM250. The other functions of the light effect panel
are then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Number of Start address
DMX channels (example)
8 33
11 33
• Press the MENU button and select, via the directional buttons, the [Intro] menu choice, then press the
ENTER button to confirm the choice.
• Press the UP and DOWN buttons to select [Address] menu voice and confirm the choice by pressing the
ENTER button.
• Edit the DMX address value into the [1 - 512] range using the UP and DOWN buttons.
CROMOBEAM250
1 2
3
120
Used DMX Next possible start
addresses address for unit No.1
33-40
33-43
2
3
1
Example:
3 pin XLR connector
Next possible start
address for unit No.2
41
44
Next possible start
address for unit No.3
49 57
55 66
13