Section 7: Installation Of Magnification Lens (Optional) - ESAB CIGWELD 454342 Operating Manual

SECTION 7: Installation of Magnification Lens (Optional)

CIGWELD magnification lenses magnify the work area substantially to assist the welder in maintaining the high standard required.
Before installing the magnification lens, ensure that the rear cover lens is in place.
Magnification lens ordering information (optional):
0-5296
! !
WARNING
1. Magnification Lens Frame
Magnification lens frame shown on left without magnification lens installed.
2. Installing Magnification Lens
To install magnification lens, slide the magnification lens from the top of the magnification lens
frame and slide it down until it comes in contact with the last set of tabs on the magnification
lens frame. Ensure that the lens fits firmly in between the tabs.
3. Magnification Lens installed
Once the lens is installed it should sit firmly in place as shown in the picture on the left.
4. Removing Magnification Lens
To remove the magnification lens slide the magnification lens from the bottom edge in an
upwards motion until the magnification lens becomes free from the magnification lens frame.
Description
1.50 diopter
2.00 diopter
2.25 diopter
2.50 diopter
Table 7-1 Magnification Lens Ordering Information
ProLite Welding Helmet
Part Number
454012
454010
454014
454011
15