Table of Contents
Advertisement
ELAN HOME SYSTEMS
Installation
With the rough-in box installed and speaker wires pulled to the
location, installation can commence. Make wiring connections
first, then mount the Volume Control in the wall.
1. Disconnect amplifier from electricity before
starting.
2. Secure mounting plate to Volume Control with
supplied (2) phillips screws, noting 'TOP' orientation.
3. Strip back 1/4" of the insulation from the endof the
speaker wires.
4. Twist bare wires tightly making sure their are
no frayed wires.
5. Secure each wire from the amplifier to its
respective connector. Use screw terminals
to tighten.
L+ to L+, L- to L-, R+ to R+, R- to R-
6. Next, make connections to the speakers
using the same L +/-, R +/- scheme.
7. Carefully place the Volume Control in the rough-in box
making sure not to put strain on the speaker / amplifier
connections.
© ELAN Home Systems 2007 • All rights reserved.
INSTALLATION MANUAL
Page 9
Advertisement
Table of Contents
