Table of Contents
Advertisement
INSTALLATION MANUAL
8. Insert two 1" screws into the mounting holes
of the VSOS/VMOS to mount the unit into the rough-
in box. Tighten these screws until the unit is at the proper
depth to mount flush with the wall.
9.
Place Decora cover, noting TOP orientation, at top of face
place insert tab. Swing down bottom and snap into place.
10. Connect speaker wires to amplifier. Make sure
proper polarity is maintained or sound quality
will suffer.
11. Connect amplifier to power and test.
DO NOT CONNECT THE WIRES FROM
THE VOLUME CONTROL TO THE
AMPLIFIER UNTIL THE FOLLOWING
CHECKS HAVE BEEN PERFORMED!
1. With an Ohmmeter, measure the resistance between
the + and - of each pair of wires that is to be connected to the
amplifi er's speaker outputs. Under no circumstances should
this reading be below the amplifi er's minimum impedance.
A reading of less than 4 Ohms may mean that the Input and
Output plugs on the Volume Control may have been hooked
up backwards (potentially causing damage to the amplifi er).
An open reading may indicate a polarity reversal.
2. Make sure amplifi er is not powered up when making connec
tions or testing.
Page 10
ELAN HOME SYSTEMS
© ELAN Home Systems 2007 • All rights reserved.
Advertisement
Table of Contents
