Table of Contents
Advertisement
ADA-13110MG
7. FACTORY DEFAULT
User name
Password
IP address
Operating mode
Bout rate[bits/sec]
Number of data bits
Parity Control
Number of stop bits
Flow Control
8. TROUBLESHOOTING
Problem
I forgot the password
I changed the configuration and the
converter isn't functioning.
9. VERSIONS
Electronic versions:
Basic
Galvanic isolation:
1kV= from the power supply
3kV= from the power supply
1kV= 3-way
3kV= 3-way
Isolation from the power supply allows transmitting signals: Tx, Rx, RTS, CTS, DTR, DSR, DCD of RS232 interface.
3-way isolation allows transmitting signals: Tx, Rx, RTS of RS232 interface.
10. SPECIFICATION
Interfaces
Connector
Max. Line length
Max. number of connected device
Max. baud rate
Transmission line
Transmission type
Standards
Parameter
root
dbps
Obtain an IP address automatically using DHCP
RealPort
9600
8
no
1
no
Restoring Default Settings according to steps below:
1. Disconnect the power of the converter,
2. Remove the cover of ETHERNET connector,
3. Press RESET "RST" and holding the button, connect the power of the converter,
4. Release the button after 20 sec. when the converter will start with default settings.
Restoring Default Settings deletes existing configuration and the proper configuration
should be loaded to the converter from the backup.
1. Enter in the Internet browser http://converter-ip-address,
2. Select the menu [Factory Default Settings] press [Restore].
ADA-13110MG -
-
1
TECHNICAL DATA
Transmission Parameters
Depend on addressing type in network
4-pair twisted cable, UTP 4x2x0,5 (24AWG),
shield inside large interferences STP 4x2x0,5
(24AWG)).
Asynchronous transmission half duplex or full duplex.
IEEE 802.3, EIA-232, CCITT V.24
Value
Solution
Order example:
Product Symbol: ADA-13110MG-1-2
1 – basic version of electronic,
2
2 - galvanic isolation 1kV= from the power supply
3
23
33
ETHERNET
RJ45
LAN up to 150 m
10/100 Mbit/s
27
RS232
DB-9M (male)
Up to 15m
1
230,4 kbps
e.g. CAB-DB9F/DB9M-S-1,8m cable
Advertisement
Table of Contents
