Forming The Workpiece; Prerequisites; Operation Mode Buttons Control Panel - Danfoss ET4200 Operator's Manual

5.3

Forming the workpiece

5.3.1 Prerequisites

5.3.2 Operation mode buttons control panel

Prerequisites for a correct forming process:
•
The die system and the workpiece are compatible.
•
The proper jaw system is correctly mounted in the tool.
• The forming dimension is set correctly, please also refer to "Set-
ting the forming dimension", Section 5.
•
Preferably form the workpiece in the centre of the crimping die
length. Eccentric forming will result in a conical forming result
and increased lopsided wear on the die system and the bearing
plates.