Accessories - Danfoss ET4200 Operator's Manual

Crimping tool
The die system comprises base dies, intermediate dies (depending
on the application) and crimping dies.
All base dies are mounted on slide plates. The crimping dies and the
intermediate dies, if present, are attached to the base dies (2). The
intermediate dies are required if small work pieces are to be formed
on a large machine.
After the forming process, the base dies are pressed apart by the
pressure springs (3) when the tool opens. The bearing segments (1)
on the front guide the base dies axially in the tool.

Accessories

The machine can be fitted with accessories. A list of the available ac-
cessories is included in the Annex, Section "Accessories".
3.2 Accessories
The machine may be fitted with accessories. A list of the available ac-
cessories is included in the Annex, Section "Accessories".