Xilinx Alveo U200 Getting Started page 22

Updating the SC firmware can take several minutes.
IMPORTANT! If you have multiple cards installed in the system, you must run the above
program command separately for each card.
You will be asked to confirm the update, as follows. Type y and press the Enter key.
----------------------------------------------------
Actions to perform:
[0000:03:00.0] : Program Satellite Controller (SC) image
----------------------------------------------------
Are you sure you wish to proceed? [Y/n]: y
A message similar to the following will be displayed after a successful SC firmware update,
where the device management BDF is given in square brackets.
[0000:03:00.0] : Updating Satellite Controller (SC) firmware flash
image...
INFO : found 4 sections
[PASSED] : SC successfully updated < 37s >
INFO : Loading new firmware on SC
.......
INFO: Base (e.g., shell) flash images are the same.
----------------------------------------------------
Report
[0000:03:00.0] : Successfully flashed the Satellite Controller (SC)
image
[0000:03:00.0] : Base (e.g., shell) image is up-to-date.
taken.
Device flashed successfully.
******************************************************************
Warm reboot is required to recognize new SC image on the device.
******************************************************************
If the card already has the current firmware, a message similar to the following is displayed.
Device is up-to-date.
12. For DFX-1RP platforms the installation for deployment is complete. For DFX-2RP platforms,
it is necessary to program the shell partition file with path. Use the following command to
program the shell partition:
$ sudo /opt/xilinx/xrt/bin/xbmgmt program --device <management BDF>
--shell <partition file with path>
Refer to Appendix A: Programming the Shell Partition for DFX-2RP Platforms
the shell path and name.
The installation for deployment is now complete. To validate the installation was successful see
Chapter 5: Card Bring-Up and
UG1301 (v2.2) August 19, 2022
Getting Started with Alveo Accelerator Cards
Chapter 4: Installing the Deployment Software
No flashing to performed.
Validation.
xbmgmt
No actions
for obtaining
www.xilinx.com
Send Feedback
22