Xilinx Alveo U200 Getting Started page 26

Data center accelerator cards
Hide thumbs Also See for Alveo U200:
Table of Contents

Advertisement

You will be asked to confirm the update, as follows. Type y and press the Enter key.
----------------------------------------------------
Actions to perform:
[0000:03:00.0] : Program Satellite Controller (SC) image
----------------------------------------------------
Are you sure you wish to proceed? [Y/n]: y
A message similar to the following will be displayed after a successful SC firmware update,
where the device management BDF is given in square brackets.
[0000:03:00.0] : Updating Satellite Controller (SC) firmware flash
image...
INFO
: found 4 sections
[PASSED] : SC successfully updated < 37s >
INFO
: Loading new firmware on SC
.......
INFO: Base (e.g., shell) flash images are the same.
----------------------------------------------------
Report
[0000:03:00.0] : Successfully flashed the Satellite Controller (SC)
image
[0000:03:00.0] : Base (e.g., shell) image is up-to-date.
taken.
Device flashed successfully.
******************************************************************
Warm reboot is required to recognize new SC image on the device.
******************************************************************
If the card already has the current firmware, a message similar to the following is displayed.
Device is up-to-date.
11. For DFX-1RP platforms the installation for deployment is complete. For DFX-2RP platforms,
it is necessary to program the shell partition. Use the following command to program the
shell partition:
$ sudo /opt/xilinx/xrt/bin/xbmgmt program --device <management BDF> --
shell
<partition file with path>
See
Displaying Card BDF Values
Refer to
Appendix A: Programming the Shell Partition for DFX-2RP Platforms
the shell partition file with path.
The installation for deployment is now complete. To validate the installation was successful see
Chapter 5: Card Bring-Up and
UG1301 (v2.2) August 19, 2022
Getting Started with Alveo Accelerator Cards
Chapter 4: Installing the Deployment Software
No flashing to performed.
to obtain the device management BDF.
Validation.
No actions
for obtaining
www.xilinx.com
Send Feedback
26

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Alveo U200 and is the answer not in the manual?

This manual is also suitable for:

Alveo u250Alveo u280

Table of Contents