RadioLink RC8X Instruction Manual page 83

parameters for each sensor in this menu.
Receiver signal: in this menu, the current signal strength (RSSI) of receiver will display, and
the low RSSI value alarm mode, the vibration mode, the alarm limit, and the alarm interval can be
set.
Setting steps: turn on the RC8X, into home page,
click the button
System menu, click
blue select box named Sensor setting, click the
"Receiver signal" can into the menu to set the receiver
signal parameters.
Current signal: the initial value of current signal is
-100 dbm. After the RC8X have bind to the receivers
which have the signal strength telemetry function, the
RSSI value will display here and the value will vary with
the distance between the receiver and the transmitter.
Alarm mode type: it defaults "NULL", it means that if the value of current signal is lower
than the alarm limit you have set, the transmitter will alarm, sound and 20 kinds of warning can
be set.
Vibration mode: it defaults "Inhibit", Mode1, Mode2, and Mode3 can be selected.
Alarm limit: the initial low RSSI alarm value is -40dbm, it means if the current signal is less
than -40dbm, the transmitter will alarm with sound or warning. The low RSSI alarm value can set
from 0 dbm to -100 dbm, the best RSSI alarm value is depending on the control range test.
at the left bottom of RC8X into
into Telemetry menu, click the
82
RadioLink Electronic Limited
www.radiolink.com