RadioLink RC8X Instruction Manual page 27

4) The table below shows how to switch working mode, and enable gyro function on
R8FG.
Working Mode
Indicator Color
With Gyro
Telemetry
1
2
3
Channel
4
5
6
7/PPM
8/S.BUS
Signal Switch
R8FG Working Mode
Mode 1 Mode 2
Green Blue
No No
Telemetry Port of Model Battery Voltage（+ -）
TELEMETRY port is only for 2S-8S battery voltage telemetry. The port cannot be used
PWM PWM
PWM PWM
PWM PWM
PWM PWM
PWM PWM
PWM PWM
PWM PPM
PWM S.BUS
Short press
Short press ID
ID set once
set once to
to Mode
Mode 2-Blue
1-Green
indicator
indicator
Short press
Short press ID
ID set 3
set 3 times
times quickly
quickly to
to Mode
Mode 3-Red
4-Purple
indicator
indicator
Short press ID Short press
set 4 times ID set 4
quickly to times quickly
Mode to Mode
4-Purple 3-Red
indicator indicator
Mode 3
Purple(Red+B
Red
Yes
to power the receiver.
PWM
PWM
PWM
PWM
PWM
PWM
PWM
PWM
Short press
Short press ID
ID set once to
set once to
Mode
Mode 3-Red
4-Purple
indicator
Short press Short press ID
ID SET twice SET twice
quickly to quickly to
change the change the
gyro phase gyro phase
Short press Short press ID
ID set 3 times set 3 times
quickly to quickly to
Mode Mode 2-Blue
1-Green indicator;
indicator; Short press ID
Short press set 4 times
ID set 4 times quickly to
quickly to
Mode 2-Blue
indicator
26
RadioLink Electronic Limited
www.radiolink.com
Mode 4 Note
lue)
Yes
PWM Steering
PWM Throttle
PWM Aux
PWM Aux
PWM Aux
PWM Aux
PPM Aux
S.BUS
In
Purple(Red+Blue)
indicator
indicator mode,
channel 7 outputs
PPM, channel 8
outputs S.BUS.
Flight controller
can be connected
under the mode
and achieve
different models
control incl.
Mecanum
car/Robot/Self-driv
ing vehicles&
boats/Engineering
Off-road cars
Mode
1-Green
indicator