Install Wheel - RadioLink RC8X Instruction Manual

2.10.3 Install Wheel

Insert the 14pin plug, 3pin plug and 4pin plug on the steering wheel into the
1
corresponding socket in the middle of the PCB motherboard on the left side of the RC8X.
Insert the plastic steering mounting plate. When inserting part of it, gently insert the
2
extra part of the 3 connector wires into the interlayer of the RC8X PCB board.
Note: do not block the installation position of the two screws when jamming the cables.
Otherwise installing the wheel will crush the cable.
141
RadioLink Electronic Limited
www.radiolink.com