RadioLink RC8X Instruction Manual page 25

Gyro function setting
The integrated high-performance gyro adopts the software filter and PID algorithm, timely
and precisely corrects the sensitivity and improve the stability. Its good flexibility to different
models and fields easily achieves professional performance even with drift cars.
1) Enable Gyro
Gyro function of R8FG is turned off by default. Since integrated gyro in R8FG will
self-check, it is very important to remain R8FG still when powering it on. When red LED is off
means NO gyro.
Press binding button three times (interval less than 1 second), the red LED will flash three
times, indicating that gyro is enabled.
Attention:
Its normal that the servo keeps shake when connect to receiver, but the transmitter have not
operated. Because, the gyro will help to correct the steering gear angle of servo automatically if
the gyro function has turned on, you can turn off the gyro function if you do not need this
function.
If the receiver has not be moved, but the servo keep shake, there are two reasons as below:
① the servo has connect to the PPM/S.B channel of receiver, please reconnect the servo to
the CH1/2/3/4/5/6, because the standard servo only supports PWM signal input.
② the gyro is too much sensitivity, please reduce the value of gyro sensitivity by turn the
DL1 knob switch.
24
RadioLink Electronic Limited
www.radiolink.com