RadioLink RC8X Instruction Manual page 100

Throttle return: Set the ratio that the servo returns to the slow side of trigger operation. If set
to 0%, the traction control function will not work. At 50%, it returns to the neutral position at 50%
(half), 100% of the trigger operation amount.
Delay: Set the delay from when the throttle is operated until when the traction control
operation starts. When set to 0%, the traction control function works without delay. At 50%, the
traction control function works approximately 0.5 seconds later, and the traction control function
works about 1 second later at 100%.
Cycle speed: Sets the pulse speed (cycle speed). The initial value is 10, 0 to 30 can be selected.
The smaller the set value, the faster the pulse cycle.
Interval rate: Set the ratio of the time to operate to the high side and the time to operate to
the slow side in the pumping operation. The initial ratio is 0, can be set to +9 ~ +0 ~ -9 in 19
steps.
-9 indicates brake application time becomes shortest which means brakes lock with
difficulty.
9 indicates brake application time becomes longest which means brakes lock easily.
Trigger point: When the traction control mixing is turn on, in
the throttle operation, set the position that triggers the traction
control function to start to work. The initial value is 30, 5 to 95
can be selected.
Trigger mode: Normal or Reverse can be selected.
"Normal" means the high range from the trigger point to the operating range. "Reverse"
means the operating range from neutral to trigger point.
99
RadioLink Electronic Limited
www.radiolink.com