Drive Bar And Saw Chain Assemble - Fieldmann FZP 45016-B User Manual

5. DRIVE BAR AND SAW CHAIN ASSEMBLE

WARNING! Always wear protective gloves when working with the chain.
1. Make sure that the device is turned off. Place the saw on a fl at surface.
2. Move the chain brake shield to the operating position by pulling the lever toward you. Make sure the chain
rotates around the bar (fi g. 3).
3. Unscrew the two nuts (A) securing the protective cover. Remove the protective cover (B) (fi g. 4).
Fig. 3
4. Install the bar so that the bar slot aligns with both bolts (C) (fi g. 5).
5. Spread th chain in a circle with the cutting edges (D) aligned with the markings on the guide bar (fi g. 6).
6. Run the chain behind the drive chain wheel (E). Check if the chain links are well positioned between the teeth
of the chain wheel (Fig. 7).
7. Insert the links into the bar groove (F) (Fig. 7).
8. Rotate the chain to make sure the chain teeth are engaging the teeth of the chain wheel.
9. Replace the protection cover so that the bolts fi t into the holes and the chain tensioning pin fi ts into the lower
hole in the bar (fi g. 8).
CHAIN SAW
Drive bar and saw chain assemble
Fig. 4
Fig. 6
Fig. 5
Fig. 8
Fig. 7
11 EN
USER'S MANUAL