Table of Contents
Advertisement
The chain brake has two positions:
1. The brake is off (the chain can move) when the brake shield is pulled back (A) (fi g. 11).
2. The brake is on (the chain cannot move) with the brake shield pointing forward (B). In this case, the chain
should not move on the bar (fi g. 11).
Fig. 11
To check the chain brake:
1. Place the saw on a level surface and turn off the chain brake. The chain should not come into contact with
anything.
2. Start the chainsaw by pressing the throttle lock key and the throttle key.
3. Press the chain brake switch. The chain should stop quickly. Release the throttle key.
WARNING! The brake shield must be in good condition and must make a distinctive click when moving
from one position to another. Do not use the unit if the brake shield cannot be moved to one of the positions
or if the chain does not stop when the brake is applied. Take the unit to a service center for repair.
CHAIN SAW
Drive bar and saw chain assemble
Fig. 11
13
EN
USER'S MANUAL
Advertisement
Table of Contents
