Before Starting The Engine - Dolmar MS290.4U Original Instruction Manual

4. After installing the nylon cutting head, remove the
hex wrench.
1
2
► 1 . Nylon cutting head 2. Receive washer 3. Shaft
4. Hex wrench
Manual feed type
1. Install the receive washer onto the shaft.
2.
Insert the hex wrench through the hole in the gear
case.
3. Insert the nylon cutting head into the shaft and
tighten the nut.
4. After installing the nylon cutting head, remove the
hex wrench.
1
2
3
4
► 1 . Nut 2. Nylon cutting head 3. Receive washer
4. Shaft 5. Hex wrench
Hex wrench storage
CAUTION:
Be careful not to leave the hex
wrench inserted in the tool head. Doing so may
cause an injury and/or damage to the tool.
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
3
4
5
For bike handle model
1
► 1 . Knob 2. Hex wrench
For loop handle model
► 1 . Handle 2. Hex wrench
BEFORE STARTING THE
ENGINE
Basic information about engine oil
Recommended oil:
SAE 10W-30 oil of API Classification, Class SF or
higher (4-stroke engine for automobile)
Oil volume:
Approx. 0.08 L
13 ENGLISH
1
2
2