Table of Contents
Advertisement
I
NSTALLATION
Caution
Secure locking pin before operating;
locking pin must be fully released into
hole on head before the system is
operated. See Figure D.
Note
An extra head-to-canister O-ring is
supplied. This can be used as a
replacement if the O-ring has been
damaged or deformed in shipment.
Figure D: Canister locking pin position
16
4.
Lubricate the o-ring on the head with water.
Install the filter onto the head, ensure that the
plugged end is down, with the open connector
pushed securely onto the head.
5.
Lift the canister upward over the filter and tight-
en on the head 1/4 turn to the right.
Advertisement
Table of Contents
