Oracle StorageTek T10000D Manual page 18

Physical Interface
Interface Port (Host
Interface)
Ethernet Port
(RJ-45)
18 FICON – Fibre connection
19 iSCSI – Internet Small Computer System Interface
20 RDMA – Remote Direct Memory Access
21 SNMP – Simple Network Management Protocol
This document may be freely reproduced and distributed whole and intact including this Copyright notice.
FIPS 140-2
Quantity Logical Interfaces
Supported
Data Input
Data Output
2
Control Input
Status Output
Data Input
Data Output
1
Control Input
Status Output
© Copyright 2017 Oracle Corporation
Description
This interface is used to transfer user data between the
ETD and the host. When the host transfers user data to
the ETD through this interface, the ETD encrypts and
writes the data to the magnetic media. When the host
receives user data from the ETD through this interface,
the ETD delivers data read from the magnetic media that
has been decrypted by the ETD.
On hardware version 7042136 the interface can be
configured to support one of two protocols:
1) Fibre Channel, in accordance with the Fibre Channel
Protocol-3 (FCP-3), SCSI Primary Commands-3, and
SCSI Stream Commands (SSC-3) specifications
18
2) FICON , in accordance with the Fibre Channel
Single-Byte Command Code Sets-3 Mapping Protocol
(FC-SB-3), Revision 1.6 specification
3)
On hardware version 7314405 the interface supports
19
iSCSI Extensions for RDMA
2003
The primary uses of this interface is to:
1) Configure the ETD
2) Deliver encryption keys to the ETD
3) Obtain ETD status and diagnostic data
4) Download firmware to the ETD
5) Deliver status information to an SNMP
20
(iSER) version 1.0, July
21
server.
Page 18 of 51