Table of Contents
Advertisement
Table 2 – Mapping of FIPS 140-2 Logical Interfaces to StorageTek T10000D Tape Drive Physical Interfaces
Physical Interface
Tape Head
TTI connector (RS-
232)
Recessed switch
Power supply connector
14
IP – Internet Protocol
15
All unencrypted dumps shall be deleted by the CO after their creation
16
VAC – Volts Alternating Current
17
Hz - Hertz
This document may be freely reproduced and distributed whole and intact including this Copyright notice.
FIPS 140-2
Quantity
Logical Interfaces
Supported
Data Input
2
Data Output
Control Input
1
Data Output
Status Output
1
Control Input
1
Power
© Copyright 2017 Oracle Corporation
Description
Provides the interface to the magnetic tape media, where
the user data to be encrypted is written to, and where the
data to be decrypted is read from.
Tape media resides in six possible cartridge types:
1) Standard Data
2) SPORT (reduced length) Data
3) VolSafe (write-once) Data
4) Sport VolSafe Data (reduced length, write-once)
5) Cleaning
6) Diagnostic (used by a service representative)
Primarily used for tape library communications.
The operator can review the status output to determine if
the module has passed or failed different self-tests. The
status output from this port consists of messages
indicating failure and success.
Short press: Reset the module's IP
IP address (10.0.0.1)
Long press: Force ETD data dump
16
100-240 VAC
@ 50-60 Hz
14
address to the default
15
17
Page 17 of 51
Advertisement
Table of Contents
