Self-Diagnosis Reset Procedure; Use Of Sds Diagnostic Procedures - Suzuki LT-A700X 2004 Service Manual

5-22 FI SYSTEM DIAGNOSIS

SELF-DIAGNOSIS RESET PROCEDURE

• After repairing the trouble, turn the ignition switch to OFF and
turn to ON again.
• If the malfunction code indicates (C00), the malfunction is
cleared.
• Disconnect the special tool from the dealer mode coupler.
NOTE:
* Even though the malfunction code (C00) is indicated, the previ-
ous malfunction history code still remains stored in the ECM.
Therefore, erase the history code memorized in the ECM using
SDS.
* The malfunction code is memorized in the ECM also when the
wire coupler of any sensor is disconnected. Therefore, when a
wire coupler has been disconnected at the time of diagnosis,
erase the stored malfunction history code using SDS.

USE OF SDS DIAGNOSTIC PROCEDURES

NOTE:
* Don't disconnect the coupler from ECM, the battery cable from
the battery, before confirming the malfunction code (self-diag-
nostic trouble code) stored in memory. Such disconnection will
erase the memorized information in ECM memory.
* Malfunction code stored in ECM memory can be checked by
the SDS.
* Be sure to read "PRECAUTIONS for Electrical Circuit Service"
( $ 5-2) before inspection and observe what is written there.
• Remove the seat. ($8-4)
• Set up the SDS tool. (Refer to the SDS operation manual for
further details)
• Read the DTC (Diagnostic Trouble Code) and "Show data
when trouble" (displayed data at the time of DTC) according
to instructions displayed on SDS.
• Not only is SDS used for detecting Diagnostic Trouble Codes
but also for reproducing and checking on screen the failure
condition as described by customers using the trigger.
• How to use trigger. (Refer to the SDS operation manual for
further details)
% 09904-41010: SDS Set
99565-01010-005: CD-ROM Ver.5