Attaching The Bucket - Kubota K008-5 Operating Instructions Manual

Accessories
Pull O-ring (6) from the nut to bearing eye (5).

Remove bolts (2) and (3) from the bearing boreholes.

Make sure not to lose the spacers (figure above/8).

Start the engine and raise the arm and/or the boom slightly until

the bucket is exposed.
If a new bucket is not to be attached right away, insert the

O-rings, bolts and spacers into the bearing boreholes and se-
cure them from being lost with the safety pins.

Attaching the bucket

Ensure that the components indicated below are free of dirt and

dust.
Ensure that an O-ring (6) is attached to each bearing eye (5).

Check the O-rings and dust protection seals (7) for damage, re-

place them if necessary.
W9215-8135-1
06/2021
5
4
3
5
6
7
8
1
2
6
7
8
163