Kubota K008-5 Operating Instructions Manual page 166

Align the bearing borehole of the arm (4) with the bearing bore-

hole (3) on the bucket.
Insert a spacer (figure above/8) on each side of the arm

bearing (3).
The axial clearance must be within 0.6 mm. If the
clearance is larger, then insert appropriate spacers.
Drive the bolts (3) into the bearing borehole.

Align the bearing borehole of the bucket linkage (1) with the

bearing borehole (2) on the bucket.
Drive the bolts into the bearing borehole.

Screw on the safety pins in order to hold the bolts in position.

Insert the O-rings from the bearing eyes down into the nut. Ensure that the O-ring is completely inside the nut.

Lubricate the bolts with grease.

164
4
3
Accessories
1
2
W9215-8135-1
06/2021