Placing Out Of Operation; Operating The Working Lights - Kubota K008-5 Operating Instructions Manual

Operation

Placing out of operation

Park the excavator in such a way that it cannot move
STOP
and is secured against unauthorised use.
Drive the excavator on level ground. The machine should be

parked under a roof.
All hydraulic cylinders have to be extended half way (see fig-

ure), the boom has to be in line with the excavator, the dozer
has to be lowered to the ground and the extendable track width
has to be set to standard track width.
Lock the swivel frame and the control levers (page 29,

page 30).
Reduce the engine speed to idle speed and let the engine run

for approx. 5 minutes to let it cool down.
Turn the starter switch (1) to the STOP position, remove the

key. The key must remain with the operator.
Unbuckle the seat belt.

Check the excavator for external damage and for leaks. Any

damage or leak must be repaired before the next start.
In case of a heavy accumulation of dirt in the area of the tracks

and the hinges on the front attachments, clean the excavator
(page 132).
Refuel the excavator, if necessary (page 109).


Operating the working lights

The starter switch is in the RUN position.

Press the working light switch (1) to the ON position (upper po-

sition).The working lights are turned on.
Press the switch (1) to the OFF position (lower position). The

working lights are turned off.
While working on public roads, other road users must
not be blinded.
W9215-8135-1
06/2021
1
1
105