Saving Flash Configuration Parameters (*.Fcp) - Emerson ControlWave EFM Instruction Manual

4.4.2 Saving Flash Configuration Parameters (*.FCP)

Revised Dec-2013
Copy the resulting zwt file to backup media (CD-ROM, thumb
7.
drive, etc.) If you ever need to restore the project, just open the zwt
file in ControlWave Designer, load libraries as needed, then compile
the project and download it into the ControlWave.
You must establish communications with the ControlWave using
NetView, LocalView, or TechView before you can run the Flash
Configuration utility.
Note: For detailed information on using the Flash Configuration utility,
see Chapter 5 of the OpenBSI Utilities Manual (D5081).
1. Start the Flash Configuration utility. To do this in NetView or
LocalView, right-click on the icon for this ControlWave and
choose RTU > RTU Configuration Parameters.
To do this in TechView, click Operations > Access Flash
Parameters or click the Access Flash icon
Depending upon how your system is configured, the Flash
2.
Configuration – Loading Options dialog box may open. If it
does, choose Load from device and wait for the utility to
retrieve all parameters from the ControlWave, then skip to step
4, otherwise, just proceed to step 3.
Click
3.
parameters from the ControlWave.
4. Click
then click Save. When the status line indicates successful
completion, your FCP file in done.
Operation
ControlWave EFM Instruction Manual
and wait for the utility to retrieve all
and specify a name for your FCP file,
.
4-7