Communicating With The Controlwave Efm; Default Comm Port - Emerson ControlWave EFM Instruction Manual

ControlWave EFM Instruction Manual

4.2 Communicating with the ControlWave EFM

4.2.1 Default Comm Port

Port PCB
COM1 CPU
COM2 CPU
COM3 CPU
COM4 ECOM Type 1 or Type
2
COM5 ECOM Type 1
ECOM Type 2
COM6 ECOM Type 1
ECOM Type 2
COM7 ECOM Type 1
ECOM Type 2
4-2
Recovery mode. Use Recovery mode for a firmware upgrade or a
core updump (see Chapter 5).
 Set SW1-1 (the upper DIP switch) to the Open (right) position and
SW1-2 (the lower DIP switch) to the Closed (left) position to place
the ControlWave EFM in Local mode, which is used for normal
running operations.
Figure 4-1. Mode Switch
You communicate to the ControlWave EFM by connecting a cable
between a port on your PC workstation and one of the ControlWave
EFM ports.
The port at the PC workstation must match the configuration of the
ControlWave EFM port.
As delivered from the factory, ControlWave EFM
communication ports have default settings. Table 4-1 details these
defaults.
Table 4-1. Default Comm Port Settings (by PCB)
Default Configuration
Ships from factory at RS-232; 115.2 Kbps using BSAP. Once
the default switch is OFF, a factory default of IP Point-to-Point
protocol (PPP) at 115,200 applies.
RS-232; 9600 baud, 8 bits, no parity, 1 stop bit, BSAP or
ControlWave Designer protocol
RS-485; 9600 baud, 8 bits, no parity, 1 stop bit, BSAP or
ControlWave Designer protocol
RS-232; 9600 baud, 8 bits, no parity, 1 stop bit, BSAP or
ControlWave Designer protocol
RS-485; 9600 baud, 8 bits, no parity, 1 stop bit, BSAP or
ControlWave Designer protocol
RS-232; 9600 baud, 8 bits, no parity, 1 stop bit, BSAP or
ControlWave Designer protocol
Not applicable
RS-485; 9600 baud, 8 bits, no parity, 1 stop bit, BSAP or
ControlWave Designer protocol
Not applicable
RS-485; 9600 baud, 8 bits, no parity, 1 stop bit, BSAP or
ControlWave Designer protocol
Operation Revised Dec-2013