Table of Contents
Advertisement
ControlWave EFM Instruction Manual
Figure 3-7. Non Isolated Mixed I/O Module Configuration Diagram
Software Configuration To use data from a mixed I/O module you must add a CWM_MIX
board in ControlWave Designer's I/O Configurator, and then configure
it. See the ControlWave Designer Programmer's Handbook (D5125)
for more information. That same manual includes an I/O Mapping
section that describes, for advanced users, the I/O map for this module.
Revised Dec-2013
I/O Modules
3-15
Advertisement
Table of Contents
Troubleshooting
