Emerson ControlWave EFM Instruction Manual page 89

ControlWave EFM Instruction Manual
Installing the RTD
To install the RTD probe, screw the fitting body into the thermowell
Probe with a 7/8" open-end wrench. While you apply pressure against the
sheath to force the tip of the RTD probe into the bottom of the
thermowell (so that the probe tip is in contact with the bottom of the
thermowell), tighten the 9/16" nut using an open-end wrench against
the 7/8" fitting body.
Figure 3-9. RTD Probe Installation/Removal Diagram
Software Configuration To use data from the RTD your ControlWave project must include a
CWM_ECPU which you set up using ControlWave Designer's I/O
Configurator. See the ControlWave Designer Programmer's Handbook
(D5125) for more information. That same manual includes an I/O
Mapping section that describes, for advanced users, the I/O map for
this module.
Revised Dec-2013 I/O Modules 3-17