Table of Contents
Advertisement
Chapter 4 - Operation
In This Chapter
WARNING
4.1 Powering Up/Powering Down the ControlWave EFM
Mode Switch
Revised Dec-2013
This chapter provides general operational details for using the
ControlWave EFM.
4.1
Powering Up/Powering Down the ControlWave EFM ..................... 4-1
4.2
Communicating with the ControlWave EFM .................................... 4-2
4.2.1
Default Comm Port ............................................................... 4-2
4.2.2
Changing Port Settings ........................................................ 4-3
4.2.3
Collecting Data from the ControlWave EFM ........................ 4-4
4.3
4.4
Creating and Maintaining Backups .................................................. 4-5
4.4.1
Creating a Zipped Project File (*.ZWT) For Backup ............ 4-5
4.4.2
Saving Flash Configuration Parameters (*.FCP) ................. 4-7
4.4.3
Backing up Data ................................................................... 4-8
EXPLOSION HAZARD
Substitution of components may impair suitability for use in Class I,
Division 2 environments.
When the ControlWave EFM is situated in a hazardous location, turn off
power before servicing or replacing the unit and before installing or
removing I/O wiring.
Do not disconnect equipment unless the power is switched off or the
area is known to be non-hazardous.
The ControlWave EFM receives power from either an external bulk
power or a rechargeable lead acid battery and solar panel combination.
Power connects to connector TB1 on the SCM. Chapter 2 includes
instructions for wiring power supply to the ControlWave EFM.
To apply power to the ControlWave EFM, plug the power supply into
connector TB1 on the SCM.
To remove power from the ControlWave EFM, unplug the power
supply from connector TB1 on the SCM.
The mode switch (SW1) is a two-position piano type DIP switch that
allows you to configure the mode for firmware upgrades, core
updumps, or normal running operations (see Figure 4-1).
Set both DIP switches to either the Open position (to the right) or
the Closed position (to the left) to place the ControlWave EFM in
Operation
ControlWave EFM Instruction Manual
4-1
Advertisement
Table of Contents
Troubleshooting
